Risk-Based Inspection (RBI) or RISK BASED INSPECTION (SCHEDULE M & WHO TRS 986-POINT (8.1-8.4) is an inspection approach where regulators prioritize systems, products, and sites based on patient-risk and compliance history. Instead of treating every area equally, RBI goes deeper…
Risk-Based Inspection (RBI) is a GMP inspection planning method that prioritizes sites, systems and products based on the risk they may pose to patients and to product quality, instead of inspecting everyone in the same routine cycle. CDSCO’s RBI guidance…
In a risk-based inspection (RBI), Schedule M points 6.2–6.8 are assessed as core contamination-control controls for sterile/aseptic processing. Inspectors don’t just confirm the SOP exists—they test whether sanitation practices reliably prevent microbial and particulate contamination and whether failures would be…
In a risk-based inspection (RBI), Schedule M point 6.1 is assessed as a foundational sterility assurance control because it defines how a facility prevents microbial, particulate, and pyrogen contamination through an effective cleaning and disinfection system. Point 6.1 expects that…
Risk-Based Inspection (RBI) is a GMP approach where regulators adjust inspection frequency, depth and scope based on the estimated risk to patients and product quality (and can widen scope when risk signals appear). ECA Academy In Schedule M, Point 5.3–5.4…
Risk-Based Inspection (RBI) means the inspector allocates time, depth and sampling to the systems that create the highest patient/product-quality risk and adjusts scope based on risk signals. Schedule M – Point 5.2 (Quality Control Laboratory Design) Schedule M 5.2 requires…
In a risk-based inspection (RBI), Schedule M point 5.1 (Disposal of waste / environmental protection) is treated as a high-impact compliance and contamination-control checkpoint, because poor waste handling can create cross-contamination risks, attract pests, generate mix-ups (rejected/returned materials), and trigger…
In risk-based inspection (RBI) aligned to Schedule M expectations for utilities, points 4.30–4.31 in the CDSCO RBI checklist target a high-impact risk source: compressed air (and other process gases) that contacts product or primary containers. Even when “invisible”, contaminated air…
In a risk-based inspection (RBI), Schedule M point 4.29 expects you to “specify the system in place for the compressed gases / air used in the facility.” CDSCO RBI treats this as high risk because compressed air/gases can introduce oil,…
Risk-Based Inspection (RBI) uses quality risk management to decide the frequency, depth and breadth of inspections based on risk to patients and product quality. CDSCO In the CDSCO RBI checklist for sterile utilities, Schedule M point 4.27 and the linked…
Risk Based Inspection (RBI) – Schedule M Point 4.26 asks the firm to “Specify the arrangement for preparation of pure steam & its use.” CDSCO In RBI, this is treated as a critical utility check because pure steam is commonly…
Risk-Based Inspection (RBI) under India’s CDSCO approach uses Quality Risk Management to decide the frequency, depth and breadth of inspection based on the site’s risk to patients/product quality, and then applies a structured checklist (Schedule M + WHO + PIC/S…